Forum Smart'ny Dom

[Rozwiązany] Help for Switch IDX on Domoticz  

  RSS
Leonardo
(@leonardo)
Nowy

gentlemen

First of all I thank you for all the content presented.
This was the only place I found a firmware for the ESP8285. I use ESPEasy for a few years, but for ESP8285 it does not work.
In my project I use the SonOff RF R2 ....

The problem is in the IDX ... the IDX is in the Relay and not the Switch.

I think it would be a good option to have the IDX option in both places. If you do not want to use any, just leave it at "0".

Use Domoticz, and to change the status in the domoticz panel needs to be in the IDX switch, in the Relay it ends up generating a looping.

Can someone help me. I need to show a prototype to the university.

Thank you and I apologize for sending the message in English.

Thank you

Leonardo

From Brazil

Cytuj
Dodane : 29/12/2018 1:43 am
adrian
(@adrian)
Prezes

Hi Leonardo, 

In AFE Firmware I'm preventing looping by using special formatting of on/off actions defined in switch/relay configuration section in Domoticz

Did you try it?

  • on action: http://sonoff-ip/?device=relay&name=switch&command=on&source=domoticz 
  • off action: http://sonoff-ip/?device=relay&name=switch&command=off&source=domoticz 

OdpowiedzCytuj
Dodane : 29/12/2018 9:49 am
Leonardo
(@leonardo)
Nowy

Dear

Good Morning

Looking again at the topic:

https://www.smartnydom.pl/pierwsza-wersja-afe-firmware-dla-uzytkownikow-domoticz/

I was sending Hardware IDX, not Device.

When switching to Device idx, it worked normally.

Again thank you for all the help from this site.

All dedication.

Please send me a link to help paypay financially. For the donation link did not accept my payment from Brazil.

thank you very much.

OdpowiedzCytuj
Dodane : 30/12/2018 5:12 am
adrian
(@adrian)
Prezes

good to hear. a donation is not needed have a good day.

CHeers!

OdpowiedzCytuj
Dodane : 30/12/2018 10:10 am
Udostępnij:



Udostępnij
  • 1
    Share
  
Pracuję

Proszę Zaloguj Się lub Zarejestruj